I continue to refine my control widgets. Here is the latest incarnation. I’ve shrunk the footprint down and boosted the clock speed to 12Mhz. This module ties into the 802.15.4 network via Xbee. I’m using the Series 1 not the Pro and Zigbee. I’m not real hip on the Pro Zigbee Mesh, it seems overly complex compared to say the Synapse SNAP mesh network.

Anyhow, according to what I’ve been following on the IoT blogs and sites, 802.15.4 has about 65% of the IOT market so I’ve decided to concentrate in that direction.

Basically, this module allows you to control things like servos and digital outputs, plus it gives you a DCC logic level signal output as well. Feed that into a motor driver like the ones from Pololu and you have a nice robust DCC implementation that is network based, rather than the point to point of Bluetooth or R/C.

I’m also looking into another implementation, via the Synapse RF266 SNAP module. I had initially though I could somehow make the RF266 work with the Xbee Series 1. While I think it’s technically possible to do this, the effort involved is quite extensive. Instead, I think a minor hardware platform will make things easier and actually, more flexible, so I’ve started down that road. Essentially, I’ll use the two serial ports on the Attiny to link the two modules together. With the right firmware I should be able to hang a Xbee Series 1 network off of the SNAP network for all sorts of diabolical mesh network fun. 🙂

Comments are closed.